Username, Password And Login Rules - Dell PowerConnect B-RX Configuration Manual

Using the Web Management Interface
To change a local user password using the Web Management Interface, you must first delete the
user account, then re-add it with the new password. Use the following procedure.
NOTE
Before you can change a local user account using the Web Management Interface, you must enable
this capability by entering the CLI command "password-change any" at the global CONFIG level of the
CLI.
1. Log in to the Web Management Interface using a valid user name and password that has a
2. Select Configure->System->Management->User Account.
3. User account information is listed in a table. Click on the Delete button next to the user
4. Click on Add User Account.
5. Enter the user name in the Username field. The name cannot contain blanks.
6. Enter the password in the Password field. The password cannot contain blanks.
7.
8. Click the Add button to save the change to the device's running-config file.
9. Repeat
10. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the
The current and previous passwords are stored in the device's running configuration file in
encrypted form.
BigIron RX# show run
username admin password .....
username admin history
username readonly privilege 5 password .....
username user1 privilege 4 password .....
In the running configuration file, the user's previous passwords are displayed in encrypted form
following the history parameter.

Username, password and login rules

Regular password rules for username and password creation is the default condition for the
system. The following are the regular password rules:
•
•
•
•
If the enable strict-password-enforcement command is configured, then the following password
rules apply:
BigIron RX Series Configuration Guide
53-1002253-01
read-write privilege level.
account whose password you wish to change.
If necessary, select the management privilege level from the Privilege pulldown menu. By
default, the system assigns privilege level 5 (Read-Only), which allows the user to display
information but not to make configuration changes.
step 3 to step 8 for each user account.
configuration.
.....
A minimum of one character is required to create a password.
The last three passwords are stored in the CLI.
Passwords do not expire.
Users are not locked out (disabled) after failed login attempts.
Setting up local user accounts
4
77