Config Flowstats Timeout Ports - Extreme Networks ExtremeWare Command Reference Manual

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

Commands for Status Monitoring and Statistics

config flowstats timeout ports

config flowstats timeout <minutes> ports [<portlist> | all]

Configures the timeout value for flow records on the specified ports.

Syntax Description

Five minutes.

Usage Guidelines

The timeout is used to export flow records on an age basis. All flow records are examined at least once

every 30 minutes. If the age of the flow record is greater than the configured timeout, the record is

exported. If the flow is still active, a new flow record will be created when the next packet arrives.

For the PoS module, the

The following command configures a timeout value of 15 minutes for ports 1-8:

config flowstats timeout 15 ports 1-8

This means that flow records for these ports will be exported after they have aged 15 minutes.

This command was first available in ExtremeWare 6.1.5b20 for the PoS module only

This command was first available in ExtremeWare 6.2 for all "i" series platforms.

Platform Availability

This command is available on the "i" series platforms.

Specifies the number of minutes to use in deciding when to export flow

records. The default is five minutes.

Specifies the ports to which the timeout applies. May be in the form 1, 2, 3-5,

2:5, 2:6-2:8.

all indicates that the timeout should be set for all ports on this switch.

Note: The parameter any is not supported for the PoS module.

parameter is an integer in the range [1-1440].

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0