Dtc 1-3: Short To Another Wire Or Decreased Resistance In Driver's Airbag Inflator - Honda EP3 Service Manual

13. Check resistance between the No. 7 and the No.
'16
t e r m i n a l s a n d b e t w e e n t h e N o . 6 a n d t h e N o . 1 5
t e r m i n a l s o f S R S u n i t c o n n e c t o r A ( 1 8 P ) . T h e r e
s h o u l d b e 2 . 0 3 . 0 0 .
SRS UNIT CONNECTOR A I18P)
Wire side of female terminals
ls the resistance as specilied?
YES-Faulty SRS unit or poor contact at SRS unit
connector A (18P) and the SRS unit, check the
connection between the connector and the SRS
unit. lf the connection is OK, replace the SRS unit
( s e e p a g e 2 3 - 1 2 2 ) . 1
NO-Open or increased resistance in dashboard
wire harness B orthe cable reel; replace the cable
reel. lf the problem still present, replace dashboard
w i r e h a r n e s s B .
DTC 1-3: Short to Another Wire or Decreased
Resistance in Driver's Airbag Inflator
SpecialTools Required
. SRS inflator simulator 07SAZ-T8401 1A
. SRS simulator lead F 07XAZ-S230100
1. Erasethe DTC memory (see page 23-26).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes of{.
Does the SRS indicator stay on?
YES-Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-261.
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes,
Disconnect the driver's airbag 4P connector (A)
from the cable reel.
07sAz-T84011A
07xAz-s230100
Connectthe SRS inflator simulator {2 0
connectors) and the simulator lead F to the cable
r e e l .
Reconnect the battery negative cable.
Erase the DTC memory.
1 .
(cont'd)
23-37