Dtc Erasure (Mes Mode); Conditions For Ote Erasure - Honda CR-V 1997 Service Manual

DTC Erasure
NOTE: This operation can also be done with the Honda PGM Tester.
1, Connect the SCS service connector to the service check connector (2P) located on the passenger's side of the center
console.
2. Press the brake pedal.
3. Turn the ignition switch ON
(II)
while keeping the brake pedal pressed. Th e ABS indicator goes off after two seconds.
4. After the indicator goes off, release the brake pedal. The indicator comes on after four seconds.
5. After the indicator comes on, press the brake pedal again . The indicator goes off again after four seconds. (the brake
pedal is still pressed.)
6. After the indicator goes off, release the brake pedal again .
7. After four seconds, the indicator blinks twice for 0.3 second and the Ole is erased.
8. Confirm the DTC indication, and check that the DTC was erased.
NOTE: Always maintain these steps. If you disconnect the SCS service connector and/or fail to operate the brake pedal
according
to the indicator indication, the DTC will not be
erased.
Conditions for OTe erasure
• The vehicle is stopped.
• The SCS service connector is connected before the ignition switch is turned ON
(II).
• The brake pedal is pressed before the ignition switch is turned ON
(II).
• The SCS service connector remains connected during this procedure.
The OTC erasure stops and the ABS control unit executes the software function if at least one of the following conditions
is satisfied:
• The vehicle is not stopped.
• The SCS service connector is disconnected during this service.
• The ABS control unit receives the normal signal (which is for the ASS control unit) from a Honda PGM Tester.
• The brake pedal is not operated according to the indicator indication.
• The DTe erasure is finished.
ON
ASS INDICATOR
OFF
DEPRESSED
BRAKE PEDAL
RELEASED
- -
- -
2 sec.
-
- -
- -- --
-
-- - -
- -
Ignition switch
ON (II)
4 sec. 4 sec.
within 3 sec. within 3 sec.
----
I
I
I
I
I
I
I
_____ 1
O.3 sec .
-+
.-
4 sec. 2 sec.
~.-
L.s
within 3 sec.
0.3 sec.
-----
I
I
:
I
19-39