AT&T MERLIN LEGEND Release 4.0 Feature Reference page 452

Feature Reference
System Programming Reports
System programming reports are available when
the System Programming menu. These reports can be directed to the SMDR
printer or a printer connected to the PC used for system programming. In
addition,
Print opts
Browse option to read reports on the PC screen. See Appendix E, "Sample
Reports," for sample reports.
Centralized Telephone Programming
Centralized telephone programming allows the system manager to program
from a single location any feature that can be programmed by individual
telephone users or system operators. Centralized telephone programming can
be done on the programming console (MLX-20L) or on a PC with SPM software.
The following features can be programmed only through centralized telephone
programming (not by individual users):
Barge-In
Headset Hang Up
All SA buttons (Hybrid/PBX mode) and ICOM buttons (Key and Behind
Switch modes)
Extension Programming
Extension Programming allows telephone users and system operators to
customize their extensions to meet personal needs. Multiline telephone users
can assign a wide range of features to buttons on the telephone. Many other
settings (Call Waiting, for example) that do not require button assignment can
be programmed on both multiline telephones and single-line telephones.
Users can program their extensions by dialing programming codes or, on MLX
display telephones, selecting features from the display. When a telephone user
programs his or her extension, the system considers the extension busy;
therefore, no incoming calls ring at the telephone until programming is
completed. See Appendix C, "General Feature Use and Telephone
Programming," for instructions on how to program features on MLX, analog,
multiline, and single-line telephones.
NOTE:
When programming a feature onto a button that already has a feature assigned
to it, any light associated with that button should be off before you begin
programming. In some cases, if the light is not off, the feature remains active
(even though a new feature has been programmed onto the button). If this
happens, you can only turn off the original feature by programming a new
button with that feature and deactivating the feature with that button. You can
then delete the new feature.
452
Programming
allows you to direct reports to the PC, so you can use the
is selected from
Print opts