AT&T MERLIN LEGEND Release 4.0 Feature Reference page 242

Feature Reference
To change the status of a telephone, the DLC operator or supervisor activates
Extension Status (if not already active) and then presses a programmed button
for Status 0, Status 1, or Status 2, and finally presses the Auto Dial or DSS
button for the telephone. The DLC operator or supervisor can also change the
status of telephones by pressing the Feature button, dialing the feature code
( for Status 0,
Dial or DSS button for the extension.
NOTE:
MLX display telephone users see only the first three characters dialed (for
example,
In either Hotel or Calling Group/CMS mode, regular multiline telephone users
can change to Status 1 or Status 2 by pressing a programmed button for each
state or by pressing the Feature button and dialing the feature code (
Status 1 or
change to Status 0 by pressing the Feature button and dialing
Single-Line Telephones
A single-line telephone user can change to Status 1 (CMS or Hotel only) or
Status 2 by lifting the handset, which must be connected to an ICOM or SA line,
and dialing
only, the user can change to Status 0 by dialing
Feature Interactions
Allowed Lists and
Calling Restrictions
Callback
Direct Station
Selection
Do Not Disturb
Group Calling
242
Extension Status
for Status 1, and
) when changing the status of telephones.
for Status 2). In Calling Group/CMS mode only, the user can
for Status 1 or for Status 2. In Calling Group/CMS mode
To allow users in Hotel mode to dial emergency or other selected
numbers when the telephone is in Status 1 or 2, access must be
assigned to an Allowed List.
In Hotel mode, an extension in Extension Status 1 or 2 cannot use
Callback to request busy pools.
A calling group or CMS supervisor or a DLC with Extension Status
assigned can change the status of a group member or room by
pressing a programmed Available or Unavailable button and then
pressing the DSS button for the group member or room.
The LED next to an Auto Dial or DSS button is on when the user
activates Do Not Disturb or is busy on a call. In Release 2.0 and later,
an MLX operator can inspect the DSS button to see if a Do Not Disturb
message is posted.
Extension Status allows calling group supervisors to change and
monitor calling group member status and to enable group members to
sign in and out of the calling group.
for Status 2), and pressing the Auto
.
for
.