Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 549

Note: Enter commands in lowercase only; mixed case is for readability.
Note
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
arp
fciptunnel
ipif
iproute
iscsi
mode
slot
[ge]port
Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
Displays ARP table. Use this operand to display IP addresses, corresponding
MAC addresses, and flags.
Displays FCIP tunnel IDs, remote and local IP addresses, remote and local
WWNs, compression status, FCIP fastwrite state for the tunnel endpoint, Tape
Pipelining status, Uncommitted bandwidth rate, SACK status, Minimum
Retransmit time, Keepalive Timeout, Maximum Retransmissions, tunnel status,
tunnel uptime. You must specify all to display all FCIP tunnels or tunnel_id to
display the specified FCIP tunnel. Additional options include:
-perf Displays additional performance information.
-params Displays connection parameter information.
-ipsec Displays IKE and IPSec policy information on IPSec-enabled tunnels.
Displays the IP interface, IP address, netmask, and MTU.
Displays the IP address, mask, gateway, metrics, and flags.
Displays GbE port WWN and iSCSI Sessions.
Displays the mode of the GbE port.
For bladed systems only, specify the slot number of the port to be configured,
followed by a slash (/).
Specify the port number to be displayed, relative to its slot for bladed systems. See
switchShow for a list of valid ports.
2
portShow
2-515