Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 264

Note: Enter commands in lowercase only; mixed case is for readability.
2
firmwareDownload
Operands
By default,
selectable only in single-CP (-s) mode, in which case autoreboot is off by default. You can change these
settings interactively or using the following options:
-s
-b
-n
host
user
pfile
passwd
If no operand is specified, the operation becomes interactive and you are prompted for input.
2-230
firmwareDownload performs full install, autoreboot, and autocommit. These modes are
Specify this operand to enable single-CP mode. In dual-CP systems, this mode
enables you to upgrade a single CP and to select full install, autoreboot, and
autocommit. In single-CP systems, this mode enables you to select full install,
autoreboot, and autocommit.
Specify this operand to activate autoreboot mode. After downloading firmware,
the system must be rebooted. If single-CP mode is enabled and this operand is not
specified, you must issue the
downloaded image. If autoreboot mode is enabled, the switch reboots
automatically after the
Specify this operand to deactivate autocommit mode. By default, after running
this command and after the reboot, the switch performs a
command automatically. When this mode is disabled, the user needs to issue the
firmwareCommit
partitions of a CP.
Specify a valid FTP server name or IP address; for example, "citadel" or
"192.168.166.30". The pfile is downloaded from this host. If this operand is not
used, the pfile is considered to be accessible through a local directory.
Specify a user name for FTP server access; for example, "jdoe". This user name
is used to gain access to the host. This operand can be omitted if pfile is accessible
through a local directory or if the FTP user ID is anonymous.
Specify a fully qualified path and file name for the firmware package list,
excluding the /SWBDxx directory name: for example, if /v5.1.0/SWBD42/
release.plist is a fully qualified path and file name, specify /v5.1.0/release.plist as
the pfile, not /v5.1.0/SWBD42/release.plist. Absolute path names can be specified
using forward slash (
Specify a password. This operand can be omitted if pfile is accessible through a
local directory or if no password is required by the FTP server.
reboot command manually to activate the
firmwareDownload command has been run.
command manually to replicate the downloaded image to both
).
/
Fabric OS Command Reference Manual
firmwareCommit
Publication Number: 53-1000240-01