Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 445

Brocade fabric os command reference manual (53-1000240-01, november 2006)

Hide thumbs Also See for A7990A - StorageWorks SAN Director 4/16 Blade Switch:

Table of Contents

Note: Enter commands in lowercase only; mixed case is for readability.

This command requires a Brocade Advanced Performance Monitoring license.

This command is not supported on virtual FC ports (VE/VEX_Port), EX_Port, M (Mirror) ports and GbE

The execution of this command is subject to Admin Domain restrictions that may be in place.

The operands are as follows:

--class monitor_class The monitor class, which can be one of EE (end-to-end), FLT (filter-based), or

To display end-to-end monitor on a port at an interval of every 6 seconds:

switch:admin> perfmonitorshow --class EE 4/5 6

perfmonitorshow 53, 6: Tx/Rx are # of bytes and crc is # of crc errors

------------- ------------- ------------- ------------- -------------

============= ============= ============= ============= =============

Fabric OS Command Reference Manual

Publication Number: 53-1000240-01

ISL (interswitch link). These values are case-sensitive.

For bladed systems only, this operand specifies the slot number of the port on

which the monitor is to be added, followed by a slash (/).

Specifies the number of the port on which the monitor is to be displayed, relative

to its slot for bladed systems. Use

Specifies an interval in (5 or more) seconds. In the case of end-to-end monitor, the

Tx and Rx counts are in the unit of byte when this operand is specified. This

operand is optional; if omitted, this command displays cumulative counts.

perfMonitorShow

for a list of valid ports.