Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 473

Note: Enter commands in lowercase only; mixed case is for readability.
macaddr
netmask
mtu_size
gateway
metric
tunnel_id
local_ipaddr
remote_ipaddr
comm_rate
mirrorport [slot/]port args
Examples
To add an ARP entry:
switch:admin> portcfg arp ge0 add 192.168.255.25 00:01:02:03:04:60
Operation Succeeded
To create an IP interface:
switch:admin> portcfg ipif 4/ge0 create 192.168.100.50 255.255.255.0 1500
Operation Succeeded
Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
parameter to bring up a native IP interface for link-level diagnostics, connectivity,
and characterization of SLA.
Specifies the MAC address which corresponds to the IP address in the ARP table.
Specifies the subnet mask for the specified port or route. Uses a.b.c.d format.
Specifies the maximum transfer unit (MTU) size for the IP interface. For GE
ports on a Silkworm 7500 or an FR4-18i blade in a Silkworm 48000, valid values
are from 1500 to 2348. On a FC4-16i in a Silkworm 48000 valid values are from
1500 to 8256.
Specifies the default gateway IP address for the route.
Specifies the link metric associated with the route. Valid values are 0 to 255. The
default is 0.
Specifies the FCIP tunnel on the GbE port. Valid values are 0 through 7.
Specifies the IP address for the specified port.
Specifies the remote-side IP address of an FCIP connection.
Specifies the committed traffic rate, in Kbit/sec, on the FCIP tunnel. Valid values
are 1,544 to 1,000,000, and 0 for uncommitted.
Configures mirror port on the local port. A mirror port is used to output mirror
traffic configured by the portMirror
confirm that the port specified will be enabled as a mirror port. Once a port is
configured as a mirror port, the port can only be used as part of a mirror
connection. Possible args for mirrorport include:
--disable
Disables the configuration. When disabled, a port cannot be a mirror
port.
--enable
Enables the configuration. When mirrorport is enabled to a port, a
mirror connectin can use this port to mirror traffic.
slot
For bladed systems only, specify the slot number of the port to be
configured, followed by a slash (/).
port
Specify the number of the port to be configured, relative to its slot for
bladed systems. Use switchShow for a list of valid ports.
portCfg
command. The user will be prompted to
2
2-439