Note: Enter commands in lowercase only; mixed case is for readability.
2
ficonShow
Link Incident Description
Link Incident Type
Listener Port Type
Listener Port WWN Displays the channel HBA port World Wide Name.
Listener Type
Manufacturer
Model Number
Node Parameters
Parameters
Parm
2-220
Same as Link Incident Type.
Indicates the link incident type as one of the following:
•
Bit-error-rate threshold exceeded
•
Loss of signal or synchronization
•
NOS recognized
•
Primitive sequence timeout
•
Invalid primitive sequence for port state
•
Listener PIDSame as PID.
Same as Port Type.
Indicates the listener type as follows:
Conditional
This port receives a link incident record if no other recipients from the
established registration list have been chosen.
Unconditional
This port is always chosen as a recipient of a link incident record.
Displays the manufacturer name or code.
Displays the model number.
Same as Parameters.
Displays the node type for the switch in three bytes, 0xAABBCC:
Byte AA
0x20
FC-SB-2 and updates.
Byte BB
0x0a
Switch.
Byte CC
0x00
Port number. It is dynamically assigned whenever a link incident occurs.
Displays the incident node parameters type in three bytes, 0xAABBCC:
Byte AA
0x00
Reserved.
0x20
FC-SB-2 and updates.
0x40
Other FC-4s including FCP and updates.
0x60
FC-SB-2 and updates and other FC-4s including FCP and
updates.
0x80
FC-4 support not specified.
0xa0
Reserved.
0xc0
Reserved.
0xe0
Vendor specific.
Fabric OS Command Reference Manual
Publication Number: 53-1000240-01