Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 317

Brocade fabric os command reference manual (53-1000240-01, november 2006)

Hide thumbs Also See for A7990A - StorageWorks SAN Director 4/16 Blade Switch:

Table of Contents

Note: Enter commands in lowercase only; mixed case is for readability.

To advertise all modes of operation, when not entering this command through the serial console port,

follow this scenario for the

switch:admin> ifmodeset eth0

Exercise care when using this command.

an operating mode not supported by the network equipment to

which it is attached may result in an inability to

communicate with the system through its ethernet interface.

It is recommended that you only use this command from the

serial console port.

Are you sure you really want to do this? (yes, y, no, n): [no] y

Proceed with caution.

Auto-negotiate (yes, y, no, n): [no] y

Advertise 100 Mbps / Full Duplex (yes, y, no, n): [yes] y

Advertise 100 Mbps / Half Duplex (yes, y, no, n): [yes] y

Advertise 10 Mbps / Full Duplex (yes, y, no, n): [yes] y

Advertise 10 Mbps / Half Duplex (yes, y, no, n): [yes] y

Committing configuration...done.

To force the link for the eth0 interface from auto-negotiation to 10 Mbit/sec half-duplex operation, when

entering this command through the serial console port:

switch:admin> ifmodeset eth0

Auto-negotiate (yes, y, no, n): [yes] n

Force 100 Mbps / Full Duplex (yes, y, no, n): [no] n

Force 100 Mbps / Half Duplex (yes, y, no, n): [no] n

Force 10 Mbps / Full Duplex (yes, y, no, n): [no] n

Force 10 Mbps / Half Duplex (yes, y, no, n): [no] y

Committing configuration...done.