Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 482

Note: Enter commands in lowercase only; mixed case is for readability.
2
portCfgISLMode
Note
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
slotnumber
portnumber
mode
Examples
To enable ISL R_RDY mode on a port:
switch:admin> portcfgislmode 1/3, 1
ISL R_RDY Mode is enabled for port 3. Please make sure the PID
formats are consistent across the entire fabric.
To disable ISL R_RDY mode on a port:
switch:admin> portcfgislmode 1/3, 0
See Also configure, portCfgLongDistance,
2-448
For bladed systems only, specify the slot number of the port to display, followed
by a slash (/).
Specify the port number to display, relative to its slot for bladed systems. Use
switchShow to list valid ports.
Specify 1 to enable ISL R_RDY mode. Specify 0 to disable ISL R_RDY mode.
portCfgShow
Fabric OS Command Reference Manual
Publication Number: 53-1000240-01