Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 493

Note: Enter commands in lowercase only; mixed case is for readability.
RSCN Suppression
Persistent Disable
Mirror Port Mode
NPIV capability
Note
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands
This command has the following operands:
arp
fciptunnel
ipif
iproute
mode
slotnumber
portnumber
Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
Displays as ON when the port has RSCN suppression enabled or blank (..) when
the port has RSCN suppression disabled. This value is set by the
rscnsupr command.
Displays as ON when the port is persistently disabled. This value is set by the
portCfgPersistentDisable command.
Displays as ON when the port has Mirror Port Mode enabled or blank (..) when
the port has the Mirror Port Mode disabled. This value is set by the
mirrorport command.
Displays as ON when the port has N_Port ID Virtualization (NPIV) enabled or
blank (..) when the port has the NPIV capability disabled. This value is set by the
portCfgNPIVPort command. It is enabled by default for Condor-based ports and
disabled by default for Bloom-based ports.
Displays address resolution protocol (ARP) table.
Displays FCIP tunnels on this GbE port. Possible optional args include: all, which
displays all FCIP tunnels; tunnel_id, which displays the specified FCIP tunnel; -
ipsec, which displays IKE and IPSec policy information on IPSec-enabled
tunnels.
Displays the IP interface.
Displays the IP route.
Displays mode of a GbE port.
For bladed systems only, specifies the slot number of the port to display, followed
by a slash (/).
Specifies the port number to display, relative to its slot for bladed systems. Use
switchShow to display a list of valid ports. This operand is optional; if omitted,
this command displays information for all ports.
2
portCfgShow
portCfg
portCfg
2-459