Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 485

Note: Enter commands in lowercase only; mixed case is for readability.
Operands
This command has the following operands:
slotnumber
portnumber
distance_level
vc_translation_link_init
desired_distance
Examples To configure a switch port 63 to support a 100 Km link and be initialized using long-distance link
initialization protocol:
switch:admin> portcfglongdistance 4/15 LS 1 100
switch:admin> portshow 4/15
portCFlags: 0x1
portFlags: 0x20001
portType:
portState: 2
portPhys:
portScn:
portId:
portWwn:
Distance:
portSpeed: 2Gbps
Interrupts:
Unknown:
Lli:
Proc_rqrd:
Timed_out:
Rx_flushed:
Tx_unavail:
Free_buffer:
Overrun:
Suspended:
Parity_err:
2_parity_err:
CMI_bus_err:
See Also
configure, portCfgISLMode, portCfgTrunkPort, portCfgShow, portShow,
Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
Specifies the slot number, for bladed systems only. The slot number must be
followed by a slash (/).
Specifies a port number. Valid values for port number vary, depending on the
switch type. Use switchShow
required.
Refer to the "Description" section for information about the value.
Specifies the long-distance link-initialization sequence; 1 activates and 0
deactivates this mode. When the command is run without specifying a value, 1 is
assigned automatically for the long-distance link in VC_RDY flow control;
otherwise, 0 is assigned. This operand is optional.
Refer to the "Description" section for information about the value.
PRESENT LED
1.1
Offline
4 No_Light
0
013f00
20:3f:00:60:69:00:02:48
super long <= 100km
9 Link_failure: 0
0 Loss_of_sync: 0
9 Loss_of_sig:
0 Protocol_err: 0
0 Invalid_word: 0
0 Invalid_crc:
0 Delim_err:
0 Address_err:
0 Lr_in:
0 Lr_out:
0 Ols_in:
0 Ols_out:
0
portCfgLongDistance
to display a list of valid ports. This operand is
Frjt:
Fbsy:
9
0
0
0
0
0
0
0
switchShow
2
0
0
2-451