Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 231

Note: Enter commands in lowercase only; mixed case is for readability.
7. RANDOM 0x25, 0x7f, 0x6e, 0x9a, ...
Note
This command is supported only on SilkWorm FR4-18i blades and SilkWorm 7500 platforms.
Operands
This command has the following operands:
--slot slotnumber
-unit number
-path mode
-nmegs count
Examples
To test slot 2 with FC Router FPGA Serdes loopback sending 10 frames:
switch:admin> fcrpathtest --slot 2 -path 2 -nmegs 10
Running fcrpathtest ..............
Test Complete: fcrpathtest Pass 10 of 10
Duration 0 hr, 0 min & 18 sec (0:0:18:942).
passed.
Diagnostics When a failure is detected, the test might report one or more of the following:
• DATA
• ERRSTAT
• INIT
• PORTDIED
• STATS
• TIMEOUT
• XMIT
See Also
fcrChipTest, miniCycle,
Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
Specifies the slot number on which the diagnostic operates. The default is 0 and
operates on fixed-port-count products.
Specifies the FC Router FPGA to test. By default, all FC Router FPGA in the
specified slotnumber are used. Valid number values include:
0 FC Router FPGA 0
1 FC Router FPGA 1
2 All FC Router FPGA
Specifies the loopback point for the test. By default,
ASIC loopback. Valid mode values include:
1 Central ASIC loopback
2 FC Router FPGA Serdes loopback
3 FC Router FPGA internal loopback
Specifies the number of frames to send. The test progresses until the specified
number of frames are transmitted on each port. The default value is 10.
portLoopbackTest
2
fcrPathTest
fcrPathTest uses central
2-197