Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Command Reference Manual page 363

Note: Enter commands in lowercase only; mixed case is for readability.
Operands
This command has the following operands:
slotnumber
portnumber
cost
If no operands are specified, the current link costs for all ports on the switch.
Examples
To display the cost of a link and set that cost:
switch:admin> linkcost
Slot
--------------------------------------
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
Type <CR> to continue, Q<CR> to stop:
switch:admin> linkcost 2/4 500
switch:admin> linkcost 2/4
Interface2/4
switch:admin> linkcost 2/4 0
switch:admin> linkcost 2/4
Interface2/4
See Also interfaceShow, lsDbShow, topologyShow, uRouteShow,
Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
For bladed systems only, specify the slot number of the port to display, followed
by a slash (/).
Specify the port number to display, relative to its slot for bladed systems. Use
switchShow to list valid ports. This operand is optional; if omitted, the cost of all
ports is displayed.
Specify the new cost of the link connected to the specified port number. If cost is
0, this port will then revert to its default link cost. This operand is optional. If
omitted, this command displays the cost of the specified port.
Interface Cost
0 500 (STATIC)
1 1000
2 500 (STATIC)
3 200 (STATIC)
4 1000
5 1000
6 1000
7 1000
8 1000
9 1000
10 1000
11 (E_PORT) 2000 (STATIC)
12 1000
13 1000
14 1000
15 1000
Cost 500 (STATIC)
Cost 1000
linkCost
fcrRouterPortCost
2
2-329