Debug Stp Config Ports - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
22-10 no debug address_binding
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an
ARP/IP packet or a DHCP packet.
Format
no debug address_binding
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To stop IMPB debug: starting when the IMPB module receives an ARP/IP or DHCP packet:
DWS-3160-24PC:admin# no debug address_binding
Command: no debug address_binding
Success.
DWS-3160-24PC:admin#

22-11 debug stp config ports

Description
This command used to configure per-port STP debug level on the specified ports.
Format
debug stp config ports [<portlist> | all] [event | bpdu | state_machine | all] state [disable |
brief | detail]
Parameters
ports - Specifies the STP port range to debug.
<portlist> - Enter the list of port used for this configuration here.
all - Specifies to debug all ports on the Switch.
event - Debug the external operation and event processing.
bpdu - Debug the BPDU's that have been received and transmitted.
state_machine - Debug the state change of the STP state machine.
all - Debug all of the above.
state - Specifies the state of the debug mechanism.
disable - Disables the debug mechanism.
brief - Sets the debug level to brief.
261