Chapter 28 Filter Command List - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide

Chapter 28 Filter Command List

config filter netbios [<portlist> | all] state [enable | disable]
show filter netbios
config filter extensive_netbios [<portlist> | all] state [enable | disable]
show filter extensive_netbios
28-1 config filter netbios
Description
This command is used to configure the Switch to deny the NETBIOS packets on specific ports.
Format
config filter netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Specifies the list of ports used.
all – Specifies that all the ports will be used for the configuration.
state- Specifies the state of the filter to block the NETBIOS packet.
enable - Specifies that the state will be enabled.
disable - Specifies that the state will be disabled.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure filter netbios state:
DWS-3160-24PC:admin# config filter netbios 1-10 state enable
Command: config filter netbios 1-10 state enable
Success.
DWS-3160-24PC:admin#
28-2 show filter netbios
Description
This command is used to display the NETBIOS filter state on the Switch.
Format
show filter netbios
303