D-Link DWS-3160-24TC Cli Reference Manual page 116

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
access_id - Specifies the index of the access list entry. If the auto_assign option is selected, the
access ID is automatically assigned.
<value 1-128> - Enter the access ID used here. This value must be between 1 and 128.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a port-base egress access rule that when the packet go out Switch which match the
specified source IP, DSCP and destination IP field, it will not be dropped:
DWS-3160-24PC:admin# config egress_access_profile profile_id 2 add access_id
auto_assign ip source_ip 10.0.0.1 dscp 25 destination_ip 10.90.90.90 port_group
id 1 permit
Command: config egress_access_profile profile_id 2 add access_id auto_assign ip
source_ip 10.0.0.1 dscp 25 destination_ip 10.90.90.90 port_group id 1 permit
Success.
DWS-3160-24PC:admin#
To configure a vlan-base egress access rule that when the packet go out Switch which match the
specified source MAC field, it will be dropped:
DWS-3160-24PC:admin# config egress_access_profile profile_id 2 add access_id 1
ethernet source_mac 11-22-33-44-55-66 vlan_based vlan_id 1 deny
Command: config egress_access_profile profile_id 2 add access_id 1 ethernet
source_mac 11-22-33-44-55-66 vlan_based vlan_id 1 deny
Success.
DWS-3160-24PC:admin#
7-4 show egress_access_profile
Description
This command is used to display current egress access list table.
Format
show egress_access_profile {[profile_id <value 1-4> | profile_name <name 1-32>]}
Parameters
profile_id - (Optional) Specifies the index of the egress access list profile.
<value 1-4> - Enter the profile ID here. This value must be between 1 and 4.
profile_name - (Optional) Specifies the name of the profile. The maximum length is 32
characters.
<name 1-32> - Enter the profile name here. This name can be up to 32 characters long.
If no parameter is specified, will display the all egress access profile.
112