Setting The Switch's Ip Address - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
NOTE: The first user automatically gets Administrator level privileges. At least one
Admin-level user account must be created for the Switch.
1-2

Setting the Switch's IP Address

Each Switch must be assigned its own IP Address, which is used for communication with an
SNMP network manager or other TCP/IP applications. The Switch's default IP address is
10.90.90.90. You can change the Switch's default IP address to fit into your networking address
range.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be
changed, and can be found by entering the command "show switch" into the command line
interface, as displayed below.
DWS-3160-24PC:admin#show switch
Command: show switch
Device Type
MAC Address
IP Address
VLAN Name
Subnet Mask
Default Gateway
Boot PROM Version
Firmware Version
Hardware Version
System Name
System Location
System Uptime
System Contact
Spanning Tree
GVRP
IGMP Snooping
MLD Snooping
VLAN Trunk
Telnet
Web
SNMP
SSL Status
CTRL+C ESC q Quit
The IP address of the Switch must be configured before it can be managed, by the user, via the
Web User Interface.
An example to change the IP address of the Switch to '10.90.90.91', using a subnet mask of
'255.0.0.0':
: DWS-3160-24PC Gigabit Ethernet Switch
: 00-11-22-33-45-67
: 10.90.90.90 (Manual)
: default
: 255.0.0.0
: 0.0.0.0
: Build 1.00.001
: Build 1.00.034
: A1
:
:
: 0 days, 6 hours, 39 minutes, 0 seconds
:
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled (TCP 23)
: Enabled (TCP 80)
: Disabled
: Disabled
SPACE n Next Page ENTER Next Entry a All
3