D-Link DWS-3160-24TC Cli Reference Manual page 472

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
members of the multicast VLAN. The PVID of the untagged source port is automatically
changed to the multicast VLAN. Source ports must be either tagged or untagged for any single
multicast VLAN, i.e. both types cannot be members of the same multicast VLAN.
<portlist> - Enter the list of port to be configured here.
state - (Optional) Used to Specifies if the multicast VLAN for a chosen VLAN should be enabled
or disabled.
enable - Specifies to enable the multicast VLAN for a chosen VLAN.
disable - Specifies to disable the multicast VLAN for a chosen VLAN.
replace_source_ipv6 - (Optional) Before forwarding the report packet sent by the host, the
source IP address in the join packet must be replaced by this IP address. If none is specified,
the source IP address will not be replaced.
<ipv6addr> - Enter the replace source IPv6 address here.
remap_priority - (Optional) The remap priority value to be associated with the data traffic to be
forwarded on the multicast VLAN. If none is specified, the packet's original priority is used.
The default setting is none.
<value 0-7> - Enter the remap priority value here. This value must be between 0 and 7.
replace_priority - (Optional) The packet priority is changed to the remap_priority, but only if the
remap_priority is set.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure an MLD snooping multicast VLAN with the name "mv2", make ports 1 and 3 members
of the VLAN, and set the state to enable:
DWS-3160-24PC:admin#config mld_snooping multicast_vlan mv2 add member_port 1,3
state enable
Command: config mld_snooping multicast_vlan mv2 add member_port 1,3 state
enable
Success.
DWS-3160-24PC:admin#
46-3 create mld_snooping multicast_vlan_group_profile
Description
This command is used to create an MLD snooping multicast group profile on the Switch.
Format
create mld_snooping multicast_vlan_group_profile <profile_name 1-32>
Parameters
<profile_name 1-32> - Enter the multicast VLAN group profile name here. The name can be up
to 32 characters long.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
468