D-Link DWS-3160-24TC Cli Reference Manual page 816

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
DWS-3160-24PC:admin#config wireless certificate_request peer 192.168.69.123
start
Command: config wireless certificate_request peer 192.168.69.123 start
Success.
DWS-3160-24PC:admin#
91-5 config wireless cluster exchange_certificate
Description
This command is used to initiate trigger exchanges of X.509 certificates on the Switches and APs.
This command can be triggered only when network mutual authentication is enabled.
Format
config wireless cluster exchange_certificate
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To initiate wireless cluster exchange certificates:
DWS-3160-24PC:admin#config wireless cluster exchange_certificate
Command: config wireless cluster exchange_certificate
Are you sure you want to trigger exchange of X.509 certificates in the cluster?
(y/n) y
X.509 certificates exchange has been triggered.
Success.
DWS-3160-24PC:admin#
91-6 config wireless mutual_authentication_mode
Description
This command is used to configure the mutual authentication mode for the entire network or a
cluster. This command causes the configuration to be updated and saved on all the Switches in
the cluster. Switches and APs in the cluster will receive a X.509 certification used in mutual
authentication. Mutual authentication provides security, when adding Switches and APs to the
wireless network.
If Mutual authentication mode is enabled, the APs and Switches will perform the X.509 Mutual
Certificate exchange. Each device compares the certificate received from the remote end-point
812