Config Dscp Trust - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
Restrictions
None.
Example
To display HOL prevention state on the Switch.
DWS-3160-24PC:admin#show hol_prevention
Command: show hol_prevention
Device HOL Prevention State: Enabled
DWS-3160-24PC:admin#

59-16 config dscp trust

Description
This command is used to configure the state of DSCP trust per port. When DSCP is not trusted,
802.1p is trusted.
Format
config dscp trust [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of port used for this configuration here.
all - Specifies that the command apply to all ports on the Switch.
state - Enable or disable to trust DSCP. By default, DSCP trust is disabled.
enable - Specifies that the DSCP trust state will be enabled.
disable - Specifies that the DSCP trust state will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable DSCP trust on ports 1-8.
DWS-3160-24PC:admin#config dscp trust 1-8 state enable
Command: config dscp trust 1-8 state enable
Success.
DWS-3160-24PC:admin#
562