D-Link DWS-3160-24TC Cli Reference Manual page 486

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To add multicast address profile 2 to ports 1 and 3:
DWS-3160-24PC:admin# config limited_multicast_addr ports 1,3 add profile_id 2
Command: config limited_multicast_addr ports 1,3 add profile_id 2
Success.
DWS-3160-24PC:admin#
47-7 config max_mcast_group
Description
This command is used to configure the maximum number of multicast groups that a port can join.
If the IPv4 or IPv6 option is not specified, IPv4 is implied. When the joined groups for a port or a
VLAN have reached the maximum number, the newly learned group will be dropped if the action is
specified as drop. The newly learned group will replace the eldest group if the action is specified
as replace.
Format
config max_mcast_group [ports <portlist> | vlanid <vlanid_list] {[ipv4 | ipv6]} {max_group
[<value 1-1024> | infinite] | action [ drop | replace]}(1)
Parameters
ports - Specifies the range of ports to configure the max_mcast_group.
<portlist> - Enter the list of ports to be configured here.
vlanid - Specifies the VLAN ID to configure max_mcast_group.
<vlanid_list> - Enter the VLAN ID list here.
ipv4 - (Optional) Specifies that the maximum number of IPv4 learned addresses should be
limited.
ipv6 - (Optional) Specifies that the maximum number of IPv6 learned addresses should be
limited.
max_group - (Optional) Specifies the maximum number of multicast groups.
<value 1-1024> - Enter the maximum group value here. This value must be between 1 and
1024.
infinite - Specifies that the maximum group value will be set to infinite.
action - (Optional) Specifies the action for handling newly learned groups when the register is
full.
drop - The new group will be dropped.
replace - The new group will replace the eldest group in the register table.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
482