Show Dscp Trust; Config Dscp Map - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide

59-17 show dscp trust

Description
This command is used to display the DSCP trust state for the specified port(s) on the Switch.
Format
show dscp trust {<portlist>}
Parameters
<portlist> - (Optional) A range of ports to display.
If not Specifies the port, all ports for DSCP trust status on the Switch will be displayed.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To display the DSCP trust status on ports 1-8:
DWS-3160-24PC:admin#show dscp trust 1-8
Command: show dscp trust 1-8
Port DSCP-Trust
---- ----------
1 Enabled
2 Enabled
3 Enabled
4 Enabled
5 Enabled
6 Enabled
7 Enabled
8 Enabled
DWS-3160-24PC:admin#

59-18 config dscp map

Description
This command is used to configure the mapping of DSCP priorities.
The mapping of DSCP to priority will be used to determine the priority of the packet (which will be
then used to determine the scheduling queue) when the port is in DSCP trust state.
The mapping of DSCP to color will be used to determine the initial color of the packet when the
policing function of the packet is color aware and the packet is DSCP-trusted.
The DSCP-to-DSCP mapping is used in the swap of DSCP of the packet when the packet is
ingresses to the port. The remaining processing of the packet will base on the new DSCP. By
default, the DSCP is mapped to the same DSCP.
563