D-Link DWS-3160-24TC Cli Reference Manual page 501

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
true - Specifies that the port can be set to propagate a topology change.
false - Specifies that the port cannot be set to propagate a topology change.
fbpdu - (Optional) To decide if this port will flood STP BPDU when STP functionality is disabled.
When the state is set to enable, the received BPDU will be forwarded. When the state is set to
disable, the received BPDU will be dropped.
enable - Specifies that the port can be set to flood the STP BPDU when the STP functionality
is disabled.
disable - Specifies that the port cannot be set to flood the STP BPDU when the STP
functionality is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure STP ports:
DWS-3160-24PC:admin# config stp ports 1 externalCost auto
Command: config stp ports 1 externalCost auto
Success.
DWS-3160-24PC:admin#
48-15 config stp mst_ports
Description
This command is used to configure the ports management parameters.
Format
config stp mst_ports <portlist> instance_id <value 0-15> {internalCost [auto | <value 1-
200000000>] | priority <value 0-240>}
Parameters
mst_ports - Specifies to be distinguished from the parameters of ports only at CIST level.
<portlist> - Enter a list of ports used for the configuration here.
instance_id - Specifies the instance ID used.
<value 0-15> - Enter the instance ID used here. This value must be between 0 and 15.
internalCost - (Optional) Specifies the port path cost used in MSTP.
auto - Specifies that the internal cost value will be set to auto.
<value 1-200000000> - Enter the internal cost value here. This value must be between 1 and
200000000.
priority - (Optional) Specifies the port priority value.
<value 0-240> - Enter the port priority value here. This value must be between 0 and 240.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
497