D-Link DWS-3160-24TC Cli Reference Manual page 181

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
Authenticated Users - Displays the number of authenticated users connected to the network
through this Captive Portal.
Configured Locales - Displays the number of locales defined for this Captive Portal.
Interface Description - Describes the interface.
Block Status - Displays the blocked status, which is Blocked or Not Blocked.
Disable Reason - If the Captive Portal is disabled, this field indicates the reason.
CP Mode - Displays whether the CP is enabled or disabled.
Protocol Mode - Displays the current connection protocol, which is either HTTP or HTTPS.
Verification Mode - Displays the current account type, which is Guest, Local, or RADIUS.
URL Redirect Mode - Displays whether the Redirect URL Mode is enabled or disabled.
Max Bandwidth Up (bytes/sec) - Displays the maximum rate in bytes per second (Bps) at which
a client can send data into the network.
Max Bandwidth Down (bytes/sec) - Displays the maximum rate in bytes per second (Bps) at
which a client can receive data from the network.
Max Input Octets (bytes) - Displays the maximum number of octets a client is allowed to
receive.
Max Output Octets (bytes) - Displays the maximum number of octets a client is allowed to
transmit.
Max Total Octets (bytes) - Displays the maximum number of octets a client is allowed to
transfer, i.e., the sum of octets transmitted and received.
Session Timeout (seconds) - Displays the number of seconds a user is permitted to remain
connected to the network. Once the Session Timeout value is reached, the user is logged out
automatically. A value of 0 means that the user does not have a session timeout limit.
Idle Timeout (seconds) - Displays the number of seconds the user can remain idle before the
switch automatically logs the user out. A value of 0 means that the user will not be logged out
automatically.
Locale Code - Displays the two-letter abbreviation for languages.
15-10 config captive_portal client deauthenticate
Description
This command is used to deauthenticate a specific Captive Portal client or all Captive Portal clients.
Format
config captive_portal client deauthenticate {[<int 1-10> | <macaddr>]}
Parameters
<int 1-10> - (Optional) Enter a Captive Portal configuration ID, used to indicate the Captive Portal
configuration that the client is de-authenticating from, here. This value must be between 1 and
10.
<macaddr> - (Optional) Enter the MAC address of the client to deauthenticate here.
If no parameter is specified, then all clients will be deauthenticated from the Captive Portal.
Restrictions
Only Administrators can issue this command.
Example
To deauthenticate all Captive Portal clients:
177