Chapter 33 Igmp Snooping Multicast (Ism) Vlan Command List - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
Chapter 33 IGMP Snooping Multicast
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority [<value
0-7> | none] {replace_priority}}
config igmp_snooping multicast_vlan <vlan_name 32> {[add | delete] [member_port <portlist> |
[source_port <portlist> | untag_source_port <portlist>] | tag_member_port <portlist>] | state
[enable | disable] | replace_source_ip <ipaddr> | remap_priority [<value 0-7> | none]
{replace_priority}}(1)
create igmp_snooping multicast_vlan_group_profile <profile_name 1-32>
config igmp_snooping multicast_vlan_group_profile <profile_name 1-32> [add | delete]
<mcast_address_list>
delete igmp_snooping multicast_vlan_group_profile [profile_name <profile_name 1-32> | all]
show igmp_snooping multicast_vlan_group_profile {<profile_name 1-32>}
config igmp_snooping multicast_vlan_group <vlan_name 32> [add | delete] profile_name
<profile_name 1-32>
show igmp_snooping multicast_vlan_group {<vlan_name 32>}
delete igmp_snooping multicast_vlan <vlan_name 32>
enable igmp_snooping multicast_vlan
disable igmp_snooping multicast_vlan
config igmp_snooping multicast_vlan forward_unmatched [disable | enable]
show igmp_snooping multicast_vlan {<vlan_name 32>}
33-1 create igmp_snooping multicast_vlan
Description
This command is used to create an IGMP snooping multicast VLAN. More than one multicast
VLANs can be created. Newly created IGMP snooping multicast VLANs must use a unique VLAN
ID and name. They cannot use the VLAN ID or name of any existing 802.1Q VLAN.
Also keep in mind the following conditions:
•
Multicast VLANs cannot be configured or displayed using 802.1Q VLAN commands.
•
An IP interface cannot be bound to a multicast VLAN.
•
The multicast VLAN snooping function co-exists with the 802.1Q VLAN snooping function.
Format
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority
[<value 0-7> | none] {replace_priority}}
Parameters
<vlan_name 32> - Enter the multicast VLAN name here. This name can be up to 32 characters
long.
<vlanid 2-4094> - Enter the multicast VLAN ID here. This value must be between 2 and 4094.
remap_priority - (Optional) Specifies the remap priority value, to be associated with the data
traffic forwarded on the multicast VLAN.
<value 0-7> - Enter the remap priority value here. This value must be between 0 and 7.
none - Specifies that the remap priority value will be set to none. The packet's original priority
(ISM) VLAN Command List
354