D-Link DWS-3160-24TC Cli Reference Manual page 657

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
DWS-3160-24PC:admin#show log_save_timing
Command: show log_save_timing
Saving Log Method: On_demand
DWS-3160-24PC:admin#
69-13 show attack_log
Description
This command is used to display attack log messages. The attack log message refers to log
messages driven by modules such as DOS and the IP-MAC-port binding module. This type of log
message may generate a large amount of messages and quickly cause the system to run out of
system log storage. Therefore, for this type of log messages only the first log that is generated
each minute can be stored in the system log, with the rest of them being stored in a separate table
named attack log.
Format
show attack_log {index <value_list>}
Parameters
index - (Optional) The list of index numbers of the entries that need to be displayed. For
example, show attack_log index 1-5 will display the attack log messages from 1 to 5.
<value_list> - Enter the index numbers of the entries that needs to be displayed here.
If no parameter is specified, all entries in the attack log will be displayed.
Restrictions
None.
Example
To display dangerous messages on the master:
DWS-3160-24PC:admin# show attack_log index 1
Command: show attack_log index 1
Index Date
----- ---------- -------- -------- -------------------------------------------
1 2008-10-17 15:00:14 CRIT(2)
10.72.24.1 Port: 7)
DWS-3160-24PC:admin#
69-14 clear attack_log
Description
This command is used to clear the attack log.
Time Level
Land attack is blocked from (IP:
653
Log Text