Create Cfm Mep - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
vlanid - (Optional) Specifies the VLAN Identifier. Different MAs must be associated with different
VLANs.
<vlanid 1-4094> - Enter the VLAN ID used here. This value must be between 1 and 4094.
mip - (Optional) This is the control creation of MIPs.
none - Specifies not to create MIPs.
auto - MIPs can always be created on any ports in this MA, if that port is not configured with
an MEP of that MA.
explicit - MIP can be created on any ports in this MA, only if the next existing lower level has
an MEP configured on that port, and that port is not configured with an MEP of this MA.
defer - Inherit the setting configured for the maintenance domain that this MA is associated
with. This is the default value.
sender_id - (Optional) This is the control transmission of the sender ID TLV.
none - Do not transmit the sender ID TLV. This is the default value.
chassis - Transmit the sender ID TLV with the chassis ID information.
manage - Transmit the sender ID TLV with the manage address information.
chassis_manage - Transmit the sender ID TLV with the chassis ID information and the
manage address information.
defer - Inherit the setting configured for the maintenance domain that this MA is associated
with. This is the default value.
ccm_interval - (Optional) This is the CCM interval.
10ms - Specifies that the CCM interval will be set to 10 milliseconds. Not recommended.
100ms - Specifies that the CCM interval will be set to 100 milliseconds. Not recommended.
1sec - Specifies that the CCM interval will be set to 1 second.
10sec - Specifies that the CCM interval will be set to 10 seconds. This is the default value.
1min - Specifies that the CCM interval will be set to 1 minute.
10min - Specifies that the CCM interval will be set to 10 minutes.
mepid_list - (Optional) This is to Specifies the MEPIDs contained in the maintenance
association. The range of the MEPID is 1-8191.
add - Specifies to add MEPID(s).
delete - Specifies to delete MEPID(s). By default, there is no MEPID in a newly created
maintenance association.
<mepid_list> - Enter the MEP ID list here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a CFM MA:
DWS-3160-24PC:admin# config cfm ma op1 md op_domain vlanid 1 ccm_interval 1sec
Command: config cfm ma op1 md op_domain vlanid 1 ccm_interval 1sec
Success.
DWS-3160-24PC:admin#
19-5

create cfm mep

Description
This command is used to create an MEP. Different MEPs in the same MA must have a different
MEPID. MD name, MA name, and MEPID that together identify a MEP.
Different MEPs on the same device must have a different MEP name. Before creating an MEP, its
MEPID should be configured in the MA's MEPID list.
214