D-Link DWS-3160-24TC Cli Reference Manual page 893

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
DWS-3160-24PC:admin#config wireless radius accounting enable
Command: config wireless radius accounting enable
Success.
DWS-3160-24PC:admin#
95-27 config wireless static_ip
Description
This command is used to configure static IP addresses for the wireless Switch. An IP address
must be the same as an IP address of an active routing interface in order for the wireless function
to work. This IP address is used by the wireless Switch when the auto-ip-assign mode is disabled.
Format
config wireless static_ip [<ipaddr> | clear]
Parameters
<ipaddr> - Enter a valid IP address, for the wireless Switch, here.
clear - Specifies that the static IP address will reset to '0.0.0.0'.
Restrictions
Only Administrators can issue this command.
Example
To configure a static IP address for the wireless Switch:
DWS-3160-24PC:admin#config wireless static_ip 10.72.72.110
Command: config wireless static_ip 10.72.72.110
Success.
DWS-3160-24PC:admin#
95-28 config wireless trap
Description
This command is used to enable or disable wireless Switch SNMP trap groups for wireless system
events.
Format
config wireless trap [enable | disable] [all | ap_failure | ap_state | client_failure | client_state
| peer_ws | rf_scan | rogue_ap | wids_status | ws_status]
Parameters
enable - Specifies that the specified Wireless Switch SNMP trap group wireless system event will
889