D-Link DWS-3160-24TC Cli Reference Manual page 894

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
be enabled.
disable - Specifies that the specified Wireless Switch SNMP trap group wireless system event
will be disabled.
all - Specifies that all wireless SNMP traps events will be used.
ap_failure - Specifies the SNMP traps associated with AP association or authentication failures.
By default, this option is disabled.
ap_state - Specifies the SNMP traps associated with AP state changes. By default, this option is
disabled.
client_failure - Specifies the SNMP traps associated with client association or authentication
failures. By default, this option is disabled.
client_state - Specifies the SNMP traps associated with client state changes. By default, this
option is disabled.
peer_ws - Specifies the SNMP traps associated with peer Wireless Switch events. By default,
this option is disabled.
rf_scan - Specifies the SNMP traps associated with RF scan related events. By default, this
option is disabled.
rogue_ap - Specifies the SNMP traps associated with rogue access points. By default, this
option is disabled.
wids_status - Specifies the SNMP traps associated with WIDS status events. By default, this
option is disabled.
ws_status - Specifies the SNMP traps associated with wireless status events. By default, this
option is disabled.
Restrictions
Only Administrators can issue this command.
Example
To enable the wireless AP failure trap:
DWS-3160-24PC:admin#config wireless trap enable ap_failure
Command: config wireless trap enable ap_failure
Success.
DWS-3160-24PC:admin#
95-29 config wireless tunnel_mtu
Description
This command is used to configure the network MTU size for all access points. This configuration
is only used for tunneled networks and is only available if the wireless tunneling feature is enabled.
This configuration applies only to the managed access points.
NOTE: The physical ports on the wireless Switch and the rest of the network
devices must also be configured with the appropriate MTU size.
Format
config wireless tunnel_mtu [1500 | 1520 | default]
890