D-Link DWS-3160-24TC Cli Reference Manual page 166

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
Example
To enable all Captive Portal SNMP traps:
DWS-3160-24PC:admin#config captive_portal trap enable all
Command: config captive_portal trap enable all
Success.
DWS-3160-24PC:admin#
To enable the Captive Portal SNMP trap option called 'client-auth-failure':
DWS-3160-24PC:admin#config captive_portal trap enable client_auth_failure
Command: config captive_portal trap enable client_auth_failure
Success.
DWS-3160-24PC:admin#
15-5 show captive_portal
Description
This command is used to display the Captive Portal's global settings and status on the Switch.
Format
show captive_portal {[status | trap]}
Parameters
status - (Optional) Specifies to display the Captive Portal's global status.
trap - (Optional) Specifies to display the Captive Portal's SNMP trap configuration.
If no parameter is specified, then summarized information about the Captive Portal configuration
will be displayed.
Restrictions
None.
Example
To display summarized information about the Captive Portal's configuration when the Captive
Portal is enabled:
DWS-3160-24PC:admin#show captive_portal
Command: show captive_portal
Administrative Mode
Operational Status
CP IP Address
DWS-3160-24PC:admin#
: Enable
: Enabled
: 192.168.69.123
162