D-Link DWS-3160-24TC Cli Reference Manual page 794

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
must be between 0 and 192. The default value is 0, which means no limit.
default - Specifies that the default value will be used.
ip_tunnel - Specifies the Layer 3 tunnel feature. The Layer 3 Tunnel feature allows mobile
stations to maintain their IP connections while roaming from one access point to another
access point even when these access points are attached to different IP subnets. When Layer
3 tunneling is enabled the VLAN ID is not used. In fact, the Switch puts the management
VLAN ID, if any, on the tunneled packets. If the wireless network topology changes (for
example, a UWS reboots) while the Layer 3 tunneling feature is in use, you should perform an
ARP refresh on wired clients to speed up the process of re-establishing connectivity to the
tunneled network.
state - Specifies the Layer 3 Tunneling option's state. In order for the tunnel to be completely
configured, routing must be enabled and the Switch must have a routing interface IP
address that is in the tunnel subnet.
enable - Specifies that the Layer 3 tunnel feature will be enabled.
disable - Specifies that the Layer 3 tunnel feature will be disabled. This is the default
option.
subnet - Specifies the network IP address subnet used. This field must be in the same subnet
as the routing interface for the WLAN, defined on the Switch.
<ipaddr> - Enter the network IP address subnet used here.
mask - Specifies the subnet mask for the network IP address on the Layer 3 tunnel subnet.
<netmask> - Enter the subnet mask for the network IP address on the Layer 3 tunnel
subnet here.
Restrictions
Only Administrators can issue this command.
Example
To enable ARP suppression on Network 1:
DWS-3160-24PC:admin#config wireless network 1 arp_suppression enable
Command: config wireless network 1 arp_suppression enable
Success.
DWS-3160-24PC:admin#
To restore Network 1's configuration to default values:
DWS-3160-24PC:admin#config wireless network 1 clear
Command: config wireless network 1 clear
Success.
DWS-3160-24PC:admin#
To enable the Client QoS state on Network 1:
DWS-3160-24PC:admin#config wireless network 1 client_qos state enable
Command: config wireless network 1 client_qos state enable
Success.
DWS-3160-24PC:admin#
790