Chapter 89 Wireless Network Command List - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
Chapter 89 Wireless Network Command
create wireless network <int 1-64>
delete wireless network <int 1-64>
config wireless network <int 1-64> [arp_suppression [enable | disable] | clear | client_qos [state
[enable | disable] | access_control [down | up] [ip [acl_num <int 1-199> | acl_name <name
31>] | ipv6 acl_name <name 31> | mac acl_name <name 31> | clear] | bandwidth_limit [down
| up] [<uint 0-4294967295> | default] | diffserv_policy [down | up] [policy_name <name 31> |
clear]] | deny_broadcast [enable | disable] | dist_tunnel [enable | disable] | dot1x
[bcast_key_refresh_rate <int 0-86400> | session_key_refresh_rate <int>] | hide_ssid [enable |
disable] | mac_authentication [enable [local | radius] | disable] | radius [accounting [enable |
disable] | use_network_configuration [enable | disable]] | redirect [mode [http | none | default] |
url [<url> | clear]] | security mode [none | static_wep | wep_dot1x | wpa_enterprise |
wpa_personal | default] | ssid <ssid 32> | vlan [<int 1-4094> | default] | wep [authentication
[open_system {shared_key} | shared_key | default] | key [index <int 1-4> [value <string> |
clear] | length [64 | 128 | default] | type [ascii | hex | default]] | tx_key [<int 1-4> | default]] | wpa
[ciphers [ccmp {tkip} | tkip | default] | key [value <string> | clear] | versions [wpa {wpa2} | wpa2
| default]] | wpa2 [key_chching holdtime [<int 1-1440> | default] | pre_authentication [state
[enable | disable] | limit [<int 0-192> | default]]] | ip_tunnel [state [enable | disable] | subnet
<ipaddr> mask <netmask>]]
show wireless network {<int 1-64>}
89-1 create wireless network
Description
This command is used to add a wireless network configuration.
Format
create wireless network <int 1-64>
Parameters
<int 1-64> - Enter the new wireless network ID used here. This value must be between 1 and 64.
Sixteen networks are created by default. The Switch supports up to 64 networks.
Restrictions
Only Administrators can issue this command.
Example
To create a wireless network configuration:
List
784