D-Link DWS-3160-24TC Cli Reference Manual page 347

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
not activated by IGMP membership registration, but activated by the traffic. For an ordinary IGMP
snooping entry, the IGMP protocol will take care of the aging out of the entry. For a data-driven
entry, the entry can be specified not to be aged out or to be aged out by the aged timer.
When data driven learning is enabled, and the data driven table is not full, the multicast filtering
mode for all ports is ignored. That is, the multicast packets will be forwarded to router ports. If the
data driven learning table is full, the multicast packets will be forwarded according to the multicast
filtering mode.
NOTE: If a data-driven group is created and IGMP member ports are learned later,
the entry will become an ordinary IGMP snooping entry. That is, the aging out
mechanism will follow the ordinary IGMP snooping entry.
Format
config igmp_snooping data_driven_learning [all | vlan_name <vlan_name> | vlanid
<vlanid_list>] {state [enable | disable] | aged_out [enable | disable] | expiry_time <sec 1-
65535>}(1)
Parameters
vlan_name - Specifies the VLAN name to be configured.
<vlan_name> - Enter the VLAN name here.
vlanid - Specifies the VLAN ID to be configured.
<vlanid_list> - Enter the VLAN ID here.
all - Specifies all VLANs to be configured.
state - (Optional) Specifies to enable or disable the data driven learning of an IGMP snooping
group.
enable - Enter enable to enable the data driven learning option. By default, the state is
enabled.
disable - Enter disable to disable the data driven learning option.
aged_out - (Optional) Enable or disable the aging out of the entry.
enable - Enter enable to enable the aging out of the entry.
disable - Enter disable to disable the aging out of the entry. By default, the state is disabled
state.
expiry_time - (Optional) Specifies the data driven group lifetime in seconds. This parameter is
valid only when aged_out is enabled.
<sec 1-65535> - Enter the expiry time here. This value must be between 1 and 65535
seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the data driven learning of an IGMP snooping group on the default VLAN:
343