Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 131

Copyright © 2010, Juniper Networks, Inc.
Auto Detect = disabled
Inactivity Timer = disabled
In Received Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
In Discarded Packets 0
Out Forwarded Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Routed Packets 0, Bytes 0
Out Scheduler Dropped Packets 0, Bytes 0
Out Policed Packets 0, Bytes 0
Out Discarded Packets 0
IP policy input mpl_5
classifier-group C2 entry 1
0 packets, 0 bytes
filter
classifier-group C3 entry 1
0 packets, 0 bytes
filter
classifier-group C1 entry 1
0 packets, 0 bytes
forward
classifier-group *
0 packets, 0 bytes
forward
queue 0: traffic class best-effort, bound to ip ATM5/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
Attach IP policy p1 at atm 5/0.2 as output.
8.
host1(config)#interface atm 5/0.2
host1(config-subif)#ip policy output p1 statistics enable merge
host1(config-subif)#exit
Attach IP policy p2 at atm 5/0.2 as output. Merge policy mpl_5 is now attached.
9.
host1(config)#interface atm 5/0.2
host1(config-subif)#ip policy output p2 merge
host1(config-subif)#exit
Display policies to verify that mpl_5 is created.
10.
host1#show policy-list
IP Policy p1
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Policy Table
------ -----
1
Chapter 6: Merging Policies
107