Configuring Snmp Secure Packet Mirroring Traps - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Related
Documentation

Configuring SNMP Secure Packet Mirroring Traps

Copyright © 2010, Juniper Networks, Inc.
Table 60: Packet Mirroring Trap Severity Levels (continued)
Trap
juniPacketMirrorSessionReject
See Configuring SNMP in JunosE System Basics Configuration Guide for information
about JunosE Software SNMP support.
Configuring SNMP Secure Packet Mirroring Traps on page 253
mirror trap-enable
snmp-server clear secure-log
snmp-server enable traps
snmp-server host
snmp-server secure-log
show mirror trap
show snmp secure-log
To configure SNMP secure traps support, perform the following tasks on your E Series
router:
Enable packet mirroring support.
1.
Configure the packet mirroring application to generate traps.
2.
(Optional) Verify the packet mirroring trap configuration.
3.
(Optional) Configure the SNMP server to support secure logs.
4.
Configure the SNMP server to generate packet mirroring traps.
5.
Configure the SNMPv3 user for whom packet mirroring traps are generated.
6.
Configure the SNMP server to report packet mirroring traps to a remote host.
7.
(Optional) Verify the SNMP server packet mirroring configuration.
8.
The following example illustrates the procedure to configure SNMP secure packet
mirroring traps support:
host1#mirror-enable
host1#configure terminal
host1(config)#mirror trap-enable
host1(config)#show mirror trap
Traps are enabled
host1(config)#snmp-server secure-log
host1(config)#snmp-server user fredMirrorUser group mirror authentication md5
fred-md5password privacy des fred-despassword
host1(config)#snmp-server enable traps packetMirror trapFilters notice
Chapter 13: Managing Packet Mirroring
Default Severity Level
Info
253