Figure 1: Constructing An Ip Policy List - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
Related
Documentation
16

Figure 1: Constructing an IP Policy List

You can create a policy list with an unlimited number of classifier groups, each containing
an unlimited number of rules. These rules can reference up to 512 classifier entries.
If you enter a policy-list command and then enter exit, the router creates a policy list
with no rules. If the router does not find any rules in a policy, it inserts a default filter rule.
Attaching this policy list to an interface filters all packets on that interface.
NOTE: If you do not specify one of the frame-relay, gre-tunnel, ip, ipv6, l2tp,
mpls, or vlan keywords, the router creates an IP policy list. This version of the
command has been deprecated and may be removed in a future release.
You can create policy lists for ATM, Frame Relay, IP, IPv6, GRE tunnels, L2TP, MPLS, and
VLANs.
NOTE: Commands that you issue in Policy Configuration mode do not take
effect until you exit from that mode.
Policy Lists Overview on page 15
Monitoring Policy Management Overview on page 173
Copyright © 2010, Juniper Networks, Inc.