Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 137

Software for e series broadband services routers policy management configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04:
Table of Contents

Advertisement

Copyright © 2010, Juniper Networks, Inc.
color yellow
Classifier control list: C4, precedence 900
color red
Referenced by interfaces:
ATM5/0.1
input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p3
Detach p1 from atm 5/0.1. Merge policy mpl_8 is detached and deleted, and only p3
15.
is attached to this interface.
host1(config)#interface atm 5/0.1
host1(config-subif)#no ip policy input p1
host1(config-subif)#exit
Display policies to verify that p3 is attached to atm 5/0.1 and mpl_8 is removed.
16.
host1#show policy-list
IP Policy p1
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
Referenced by interfaces:
None
Referenced by profiles:
None
Referenced by merge policies:
mpl_5
IP Policy p2
Administrative state: enable
Reference count:
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 20.1.1.1, order 100, rule 3 (active)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
None
Policy Table
------ -----
1
1
Chapter 6: Merging Policies
113

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?

This manual is also suitable for:

Junose 11.3

Table of Contents