Creating Parameter Instances; Creating A Global Parameter Instance; Creating A Parameter Instance For An Interface; Creating A Parameter Instance For An Atm Vp - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

Related
Documentation

Creating Parameter Instances

Creating a Global Parameter Instance

Creating a Parameter Instance for an Interface

Creating a Parameter Instance for an ATM VP

Copyright © 2010, Juniper Networks, Inc.
behaves as if there is no shaping rate, shared-shaping rate, or assured rate for that node
or queue.
Creating Parameter Instances
For more information about using global parameter instances for IP multicast bandwidth
adjustment, see IP Multicast Bandwidth Adjustment for QoS Overview on page 253
You can create QoS parameter instances globally, for an interface, or for a subinterface.
Tasks to create parameter instances are:
Creating a Global Parameter Instance on page 227
Creating a Parameter Instance for an Interface on page 227
Creating a Parameter Instance for an ATM VP on page 227
Creating a Parameter Instance for an S-VLAN on page 228
To create a global parameter instance:
Create a parameter instance in Global Configuration mode.
host1(config)#qos-parameter max-subscriber-bandwidth 6000000
To create a parameter instance for an interface:
Specify an interface.
1.
host1(config)#interface atm 11/0.1
host1(config)#interface gigabitEthernet 2/0
Specify the parameter name and the value.
2.
host1(config-subif)#qos-parameter max-subscriber-bandwidth 6000000
Use this procedure to attach a parameter instance to a VP on the interface. Optionally,
use the qos-profile keyword to attach a parameter instance to a QoS profile.
To create a parameter instance for an ATM VP:
Configure the ATM VP.
1.
host1(config)#interface atm 2/0
host1(config-if)#atm vp-tunnel 4
Do either of the following:
2.
Attach the parameter instance to an ATM VP on the interface.
Chapter 25: Configuring a QoS Parameter
227