Creating Classifier Control Lists For Policies; Classifier Control Lists Overview; Table 3: Clacl Criteria - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

CHAPTER 2

Creating Classifier Control Lists for Policies

Classifier Control Lists Overview

Copyright © 2010, Juniper Networks, Inc.
This chapter provides information for configuring policy-based routing management on
E Series routers. See the E120 and E320 Module Guide for modules supported on the E120
and E320 Broadband Services Routers. The chapter discusses the following topics:
Classifier Control Lists Overview on page 7
Creating or Modifying Classifier Control Lists for ATM Policy Lists on page 9
Creating or Modifying Classifier Control Lists for Frame-Relay Policy Lists on page 9
Creating or Modifying Classifier Control Lists for GRE Tunnel Policy Lists on page 10
Creating or Modifying Classifier Control Lists for IP Policy Lists on page 10
Creating or Modifying Classifier Control Lists for IPv6 Policy Lists on page 12
Creating or Modifying Classifier Control Lists for L2TP Policy Lists on page 13
Creating or Modifying Classifier Control Lists for MPLS Policy Lists on page 13
Creating or Modifying Classifier Control Lists for VLAN Policy Lists on page 13
Classifier control lists (CLACLs) specify the criteria by which the router defines a packet
flow. Table 3 on page 7 lists the criteria that you can use to create CLACLs for different
types of traffic flows.

Table 3: CLACL Criteria

Type of CLACL Criteria
ATM CLP
Color
Traffic class
User packet class
Frame Relay Color
Mark discard eligibility (DE) bit
Traffic class
User packet class
7