JunosE 11.3.x Policy Management Configuration Guide
Related
Documentation
Creating Policy Lists for IPv6
22
host1(config-policy-list-classifier-group)#rate-limit-profile ipRLP25
Exit Classifier Group Configuration mode for ipCLACL10, then create a new
6.
classification group for classifier list ipCLACL20. Add a rule that filters packets based
on classifier list ipCLACL20.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#classifier-group ipCLACL20 precedence 125
host1(config-policy-list-classifier-group)#filter
Exit Policy List Configuration mode to save the configuration.
7.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
host1(config)#
Display the policy list.
8.
host1#show policy-list routeForABCCorp
IP Policy routeForABCCorp
Administrative state: enable
Reference count:
Classifier control list: ipCLACL10, precedence 75
forward
Virtual-router: default
List:
next-hop 192.0.2.12, order 10, rule 2 (active)
next-hop 192.0.100.109, order 20, rule 3 (reachable)
next-hop 192.120.17.5, order 30, rule 4 (reachable)
interface ip3/1, order 40, rule 5
mark tos 125
rate-limit-profile ipRLP25
Classifier control list: ipCLACL20, precedence 125
filter
ip policy-list
The following example creates an IPv6 policy list named routeForIPv6. For information
about creating the CLACL used in this example, see the previous sections.
Create the policy list routeForIPv6.
1.
host1(config)#ipv6 policy-list routeForIPv6
host1(config-policy-list)#
Create the classification group for the CLACL named ipv6tc67 and assign the
2.
precedence to the classification group.
host1(config-policy-list)#classifier-group ipv6tc67 precedence 75
host1(config-policy-list-classifier-group)#
Add a rule to color packets as red, and a second rule that sets the traffic class field
3.
of the packets to 7.
Policy Table
------ -----
0
Copyright © 2010, Juniper Networks, Inc.
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?