Overlapping Classification For Ip Input Policy - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Overlapping Classification for IP Input Policy

Copyright © 2010, Juniper Networks, Inc.
IP Policy P2
Administrative state: enable
Reference count:
Classifier control list: B, precedence 100, parent-group X
forward
Classifier control list: C, precedence 100, parent-group Y
forward
Classifier control list: D, precedence 100, external parent-group EPG2 parameter
abcd
forward
Parent group: X, parent-group Y
rate-limit-profile R3
Parent group: Y
rate-limit-profile R4
host1#show policy-list mpl_88000001
IP Policy mpl_88000001
Administrative state: enable
Reference count: 1
Classifier control list: *, precedence 100, parent-group Z
forward
Classifier control list: A, precedence 100, parent-group X
forward
Classifier control list: B, precedence 100, parent-group X_1
forward
Classifier control list: C, precedence 100, parent-group Y
forward
Classifier control list: D, precedence 100, external parent-group EPG2 parameter
abcd
forward
Parent group: X, parent-group Z
rate-limit-profile R1
Parent group: Z
rate-limit-profile R2
Parent group: X_1, parent-group P2_Y
rate-limit-profile R3
Parent group: Y
rate-limit-profile R4
Referenced by interfaces:
ATM5/0.1 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
P1
P2
IP auxiliary input policy can be used with IP input policy to provide overlapping
classification. Two policies, each with a set of independent rules and actions, run in
sequence so that each policy can independently produce a set of actions in sequence.
1
Policy Table
------ -----
Chapter 6: Merging Policies
117