Setting A Two-Rate Rate-Limit-Profile; Table 14: Two-Rate Rate-Limit-Profile Defaults - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Setting a Two-Rate Rate-Limit-Profile

Copyright © 2010, Juniper Networks, Inc.
You can use the rate-limit-profile two-rate command to create a rate-limit profile and
enter Rate Limit Profile Configuration mode, from which you can configure attributes for
the rate-limit profile. See Table 11 on page 83.
NOTE: The JunosE Software includes the layer 2 headers in the calculations
it uses to enforce the rates that you specify in rate-limit profiles
Use one of the ip, ipv6, l2tp, or mpls keywords in front of the command to specify the
type of rate-limit profile you want to create or modify. If you do not include one of the
keywords, the router creates an IP rate-limit profile by default.
For hierarchical rate limits, do not specify the interface type, but add the hierarchical
keyword at the end. In Parent Group Configuration Mode, associates a rate limit for a
parent group. The color-aware keyword is only supported on hierarchical rate limits.
If you do not include a one-rate or two-rate keyword, the default is a two-rate rate-limit
profile. If you enter a rate-limit-profile command and then type exit, the router creates
a rate-limit profile with the default values listed in Table 14 on page 91:

Table 14: Two-Rate Rate-Limit-Profile Defaults

Policy Attribute
type
committed-rate
committed-burst
peak-rate
peak-burst
committed-action
conformed-action
exceeded-action
mask (IP and IPv6 rate-limit profiles)
exp-mask (MPLS rate-limit profiles)
During a software upgrade, certain values are set as follows:
Chapter 5: Creating Rate-Limit Profiles
Default Value
two-rate
0
8192
0
8192
transmit
transmit
drop
255
7
91