Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 47

Copyright © 2010, Juniper Networks, Inc.
host1(config-policy-list-classifier-group)#color red
host1(config-policy-list-classifier-group)#mark tcfield 7
Exit Policy List Configuration mode to save the configuration.
4.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
host1(config)#
Display the policy list.
5.
host1#show policy-list routeForIPv6
IPv6 Policy routeForIPv6
Administrative state: enable
Reference count:
Classifier control list: ipv6tc67, precedence 75
color red
mark tc-precedence 7
You use the exception http-redirect command to create an exception rule within a policy
classifier group to specify the client application for the destination of packets rather than
forwarding them using the forwarding controller (FC).
In lower-numbered releases, the exception http-redirect command only supported the
creation of exception rules within IPv4 policy lists. You can now configure the exception
http-redirect command to create exception rules within IPv4 and IPv6 policy lists.
The following example creates an IPv6 policy list, epIPv6 for the http-redirect exception:
Create the policy list epIPv6.
1.
host1(config)#ipv6 policy-list epIPv6
host1(config-policy-list)#
Create the classification group to match all packets.
2.
host1(config-policy-list)#classifier-group *
host1(config-policy-list-classifier-group)#
Create an exception policy for http-redirect.
3.
host1(config-policy-list-classifier-group)#exception http-redirect
Exit Policy List Configuration mode to save the configuration.
4.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
host1(config)#
Display the policy list.
5.
host1#show policy-list epIPv6
IPv6 Policy epIPv6
Administrative state: enable
Reference count:
Classifier control list: *, precedence 100
Policy Table
------ -----
0
Policy Table
------ -----
0
Chapter 3: Creating Policy Lists
23