Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 130

JunosE 11.3.x Policy Management Configuration Guide
106
Component policies:
p1
p2
Show configuration.
6.
host1#show conf
! Configuration script being generated on TUE APR 26 2005 17:33:01 UTC
! Juniper Edge Routing Switch ERX1440
! Version: 9.9.9 development-4.0 (April 4, 2005
! Copyright (c) 1999-2005 Juniper Networks, Inc.
!
! Commands displayed are limited to those available at privilege level 15
!
interface atm 5/0.1
ip policy input p1 statistics enabled merge
ip policy input p2 statistics enabled merge
exit
ip policy-list p1
classifier-group C2 precedence 10
filter
classifier-group C1 precedence 90
forward next-hop 10.1.1.1
!
ip policy-list p2
classifier-group C3 precedence 10
filter
classifier-group C1 precedence 90
forward next-hop 20.1.1.1
classifier-group * precedence 1000
forward
!
! End of generated configuration script.
Display interface statistics.
7.
host1#show ip interface atm 5/0.1
ATM5/0.1 line protocol Atm1483 is up, ip is up
Network Protocols: IP
Internet address is 99.99.99.2/255.255.255.0
Broadcast address is 255.255.255.255
Operational MTU = 9180
Operational speed = 155520000
Discontinuity Time = 721112
Router advertisement = disabled
Proxy Arp = disabled
Network Address Translation is disabled
TCP MSS Adjustment = disabled
Administrative debounce-time = disabled
Operational debounce-time
Access routing = disabled
Multipath mode = hashed
Auto Configure = disabled
15:39)
Administrative MTU = 0
Administrative speed = 0
= disabled
Copyright © 2010, Juniper Networks, Inc.
All rights reserved.