Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 221

Copyright © 2010, Juniper Networks, Inc.
Referenced by profile(s):
None
Referenced by merged policies:
None
IP Policy routeForABCCorp
Administrative state: enable
Reference count:
atm-cell-mode: enabled
Classifier control list: ipCLACL10, precedence 75
exception http-redirect
forward
Virtual-router: default
List:
next-hop 192.0.2.12, order 10, rule 2 (active)
next-hop 192.0.100.109, order 20, rule 3 (reachable)
next-hop 192.120.17.5, order 30, rule 4 (reachable)
interface ip3/1, order 40, rule 5
mark tos 125
rate-limit-profile ipRLP25
Classifier control list: ipCLACL20, precedence 125
filter
IPv6 Policy routeForIPv6
Administrative state: enable
Reference count:
Classifier control list: ipv6tc67, precedence 75
color red
mark tc-precedence 7
Frame relay Policy frOutputPolicy
Administrative state: enable
Reference count:
Classifier control list: frMatchDeSet, precedence 100
mark-de 1
Frame relay Policy frInputPolicy
Administrative state: enable
Reference count:
Classifier control list: frMatchDeSet, precedence 100
color red
GRE Tunnel Policy routeGre50
Administrative state: enable
Reference count:
Classifier control list: gre8, precedence 150
color red
mark dsfield 20
filter
L2TP Policy routeForl2tp
Administrative state: enable
Reference count:
Classifier control list: *, precedence 100
color red
rate-limit-profile l2tpRLP20
MPLS Policy routeForMpls
Administrative state: enable
Reference count:
Classifier control list: *, precedence 200
mark-exp 2 mask 7
rate-limit-profile mplsRLP5
Chapter 9: Monitoring Policy Management
0
0
0
0
0
0
0
197