Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 99

Copyright © 2010, Juniper Networks, Inc.
host1#show rate-limit-profile
Rate Limit Profile Table
---- ----- ------- -----
IP Rate-Limit-Profile: rlpData
Profile Type:
Reference count:
Committed rate:
Committed burst:
Peak rate:
Peak burst:
Mask:
Committed rate action:
Conformed rate action:
Exceeded rate action:
IP Rate-Limit-Profile: rlpVoice
Profile Type:
Reference count:
Committed rate:
Committed burst:
Peak rate:
Peak burst:
Mask:
Committed rate action:
Conformed rate action:
Exceeded rate action:
IP Rate-Limit-Profile: rlpVideo
Profile Type:
Reference count:
Committed rate:
Committed burst:
Peak rate:
Peak burst:
Mask:
Committed rate action:
Conformed rate action:
Exceeded rate action:
Display policy parameters. If a rate-limit profile uses this parameter twice then it
10.
increases the reference count by 2.
host1#show policy-parameter brief
Reference-rate refRlpRate: 100000, 6 references
Display policy parameters
host1#show policy-parameter
Policy Parameter refRlpRate
Type: reference-rate
Rate: 100000
Reference count: 6
Referenced by interfaces: 1 references
IP interface ATM5/0.1: 1000000
Referenced by rate-limit profiles: 5 references
rlpData
rlpVoice
rlpVideo
Display interface atm5/0.1.
11.
Chapter 5: Creating Rate-Limit Profiles
two-rate
1
refRlpRate % 10
100 milliseconds
refRlpRate % 100
150 milliseconds
255
transmit
transmit
drop
two-rate
1
64000
100000
refRlpRate % 100
150 milliseconds
255
transmit
transmit
drop
two-rate
1
refRlpRate % 70
100 milliseconds
refRlpRate % 100
150 milliseconds
255
transmit
transmit
drop
75